Datalogic PowerScan 950X Series Instruction Manual page 93

Enter/Exit Programming Mode
Default settings are indicated at each feature/option with a green arrow.
Also reference
widely used set of standard factory settings.
To set most features:
1. Scan the ENTER/EXIT PROGRAMMING bar code at the top of applicable
2. Scan the correct bar code to set the desired programming feature or
3. If additional input parameters are needed, go to
4. Complete the programming sequence by scanning the ENTER/EXIT
82
on page 119
GS1-128
on page 138
C
ODABAR
on page 144
ABC C
ODABAR
on page 147
C 11
ODE
GS1 D B ™ O
ATA AR MNIDIRECTIONAL
GS1 D B ™ E
ATA AR XPANDED
GS1 D B ™ L
ATA AR IMITED
on page 158
C 93
ODE
on page 163
MSI
on page 168
P
LESSEY
Appendix C, Standard Defaults
programming pages.
parameter. You may need to cover unused bar codes on the page, and
possibly the facing page, to ensure that the reader reads only the bar
code you intend to scan.
and scan the appropriate characters from the keypad.
Additional information about many features can be found in the "Ref-
erences" chapter.
If you make a mistake before the last character, scan the CANCEL bar
code to abort and not save the entry string. You can then start again
at the beginning.
PROGRAMMING bar code to exit Programming Mode.
on page 151
on page 152
on page 157
for a listing of the most
PowerScan™ PD953X/PBT950X/PM950X
Appendix D, Keypad,