Table of Contents
Advertisement
References
Stand Mode Off Time
This feature specifies the amount of time reader illumination stays off after
pulling the trigger when in Stand Mode. The configurable range is 01 to 32
by 01 in increments of 500ms (500ms to 16 seconds).
Follow these instructions to set this feature:
1. Determine the desired setting.
2. Pad the result with leading zeroes to yield two digits. For example: 2 =
3. Go to
4. Scan the bar code: Set Stand Mode Illuminator Off Time.
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Program-
This completes the procedure. See
set this feature.
Table 41. Stand Mode Off Time
STEP
ACTION
1
Desired Setting
2
Pad leading zero
3
Scan ENTER/EXIT PROGRAMMING MODE
4
Scan SELECT STAND MODE OFF TIME
Scan Two Characters From
5
Appendix D, Keypad
6
Scan ENTER/EXIT PROGRAMMING MODE
294
02, 5 = 05, 20 = 20, etc.
page 72
and scan the ENTER/EXIT PROGRAMMING MODE bar code
to enter Programming Mode.
pad, that represent the setting which was determined in the steps
above. You will hear a two-beep indication after the last character.
ming Mode.
EXAMPLES
500 ms
01
'0' and '1'
Table 41
for some examples of how to
1 Second
5.5 Seconds
02
11
'0' and '2'
'1' and '1'
PowerScan™ PD953X/PBT950X/PM950X
Appendix D, Key-
16 Seconds
32
'3' and '2'
Advertisement
Table of Contents
