Datalogic PowerScan 950X Series Instruction Manual page 347

Standard Defaults
Restore Factory Configuration
If you want to restore the Factory Configuration for your imager, scan
either the Restore USA Factory Configuration bar code or the Restore EU
Factory Configuration bar code below. Both labels restore the scanner
configuration to the factory settings, including the interface type.
CAUTION
The USA label restores Label IDs to those historically used in the USA.
The EU label restores Label IDs to those historically used in Europe. The
Label ID sets for USA and EU are shown in
on page 286
336
Scanning either of the "Restore Factory Configuration" commands
below will result in the loss of any custom configuration settings
for your device. Go to
you want to restore your custom configuration settings.
of this manual.
$P,AE,P(CR)
Restore USA Factory Configuration
$P,Ae,P(CR)
Restore EU Factory Configuration
"Restore Custom Defaults" on page 17
Label ID: Pre-loaded Sets, starting
PowerScan™ PD953X/PBT950X/PM950X
if