Enter/Exit Programming Mode
ACK NAK Timeout Value
This option specifies the amount of time the reader waits for an ACK charac-
ter from the host following label transmission. The selectable timeout range
is 200 milliseconds to 15,000ms (15 seconds) in 200ms increments. A
selection of 0 disables the timeout.
See
page 274
Select ACK NAK Timeout Value Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
DEFAULT
ACK NAK Retry Count
This feature specifies the number of times the reader retries a label trans-
mission due to a retry condition. The selectable range is from 1 to 254
retries. A selection of 0 disables the count, and a selection of 255 specifies
unlimited retries. See
Select ACK NAK Retry Count Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
34
for more information on setting this feature.
01 ACK NAK Timeout value is 200ms
page 275
003 = 3 Retries
DEFAULT
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
Appendix D, Keypad
meric characters in
senting your desired character(s). End by scanning
the ENTER/EXIT bar code again.
CANCEL
for more information.
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
Appendix D, Keypad
meric characters in
senting your desired character(s). End by scanning
the ENTER/EXIT bar code again.
CANCEL
PowerScan™ PD953X/PBT950X/PM950X
repre-
repre-