Batch Features; Batch Mode; Send Batch - Datalogic PowerScan 950X Series Instruction Manual

Enter/Exit Programming Mode

Batch Mode

This option specifies whether to store labels in the handheld while discon-
nected from the base. Options are as follows:
•
•
•
DEFAULT
$CBTBM01(CR)
Batch Mode = Automatic

Send Batch

When the scanner is configured in Manual Batch Mode, use the following bar
code to initiate sending of labels stored in batch memory.
214

BATCH FEATURES

Disabled — The handheld will not store/batch labels.
Automatic — The handheld will store labels to RAM when the handheld
goes out of range and is disconnected from the remote device.
Manual — The handheld will always store labels to Flash memory. The
user must manually send the stored labels to the remote device using a
special "batch send" label.
Do not scan an ENTER/EXIT PROGRAMMING MODE label in conjunc-
tion with this bar code.
BatchSend
$CBTBM00(CR)
Batch Mode = Disabled
$CBTBM02(CR)
Batch Mode = Manual
Send Batch
PowerScan™ PD953X/PBT950X/PM950X