Enter/Exit Programming Mode
Arrow Up String (4-key models only)
Associate a pre-defined string to the Arrow Up key
$CDAUS
Set string for Arrow Up Key
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
Arrow Down String (4-key models only)
Associate a pre-defined string to the Arrow Down key
$CDADS
Set string for Arrow Down Key
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
250
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
Define the label string by further scan‐
code at left.
ning 32 digits from the Alphanumeric characters
Appendix D, Keypad
in
The digits must be the hexadecimal ASCII represen-
tation of the desired characters; if less than the
expected string of 16 characters are selected, scan
the ENTER/EXIT bar code to terminate the string.
End by scanning the ENTER/EXIT bar code again.
~
CANCEL
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left. Define the label string by further scan-
ning 32 digits from the Alphanumeric characters in
Appendix D, Keypad
.
The digits must be the hexadecimal ASCII represen-
tation of the desired characters; if less than the
expected string of 16 characters are selected, scan
the ENTER/EXIT bar code to terminate the string.
End by scanning the ENTER/EXIT bar code again.
~
CANCEL
PowerScan™ PD953X/PBT950X/PM950X
.