Arrow Keys Mode (4-Key Models Only) - Datalogic PowerScan 950X Series Instruction Manual

$CPWFZ
Enable a combination of keys (4-key models only)
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.

Arrow Keys Mode (4-key models only)

Configure the Arrow Keys functionality type. Two options are available:
Function Keys Action Select mode:
select one of the 3 possible actions associated to the Function Keys. To
associate actions to the Function keys, see
keys" on page
String Association Mode:
be programmed to display and transmit a pre-defined string (see
String (4-key models only)" on page 250
models only)" on page 250
$CDIAC00\r
Function Keys Action Select mode
Product Reference Guide
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by 4 digits from the Alphanumeric
characters in
4-key models only: The last 3 digits must always be 0;
the 4 bits of the first digit must be 1 if the corre-
sponding key is enabled; the four bits represent,
starting from the highest: Arrow Up, F2, F1, Arrow
Down. End by scanning the ENTER/EXIT bar code
again.
When in this mode, arrow keys are used to
251.
When in this mode, each one of the arrow keys can
).
$CDIAC01\r
Enter/Exit Programming Mode
Appendix D, Keypad
~
CANCEL
"Configure Actions for Function
"Arrow Down String (4-key
and
DEFAULT
String Association Mode
.
"Arrow Up
249