Table of Contents
Advertisement
Enter/Exit Programming Mode
Bluetooth Friendly Name
You can set a meaningful name for PowerScan PBT950X that will appear in
the application during device discovery.
To set a new Bluetooth Friendly Name, scan the barcode below and follow
the instructions.
$CBTFN
Set Bluetooth Friendly Name
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
Bluetooth Reconnect Attempt Mode
Enable/Disable reconnection by trigger pull.
$CBTRM01(
Bluetooth Reconnect Attempt Mode = Enable
230
POWERSCAN BPT950X
DEFAULT
[SERIAL_NUMBER_SCANNER]
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by a maximum 64 digits from
the Alphanumeric characters in
Keypad
. The digits must be the hexadecimal ASCII
representation of the desired characters. If less than
the expected string of 32 characters are selected,
scan the ENTER/EXIT bar code to terminate the
string.
~
CANCEL
$CBTRM00(CR)
Bluetooth Reconnect Attempt Mode = Disable
DEFAULT
PowerScan™ PD953X/PBT950X/PM950X
Appendix D,
Advertisement
Table of Contents
