Bc9Xx0 Configuration; Interface Selection; Setting The Interface - Datalogic PowerScan 950X Series Instruction Manual

Setup

BC9xx0 Configuration

The BC9xx0 configuration can be performed in three ways: by using the
Datalogic Aladdin
tion strings from the Host PC via the RS-232 or USB-COM interface or by
reading configuration bar codes with the PowerScan 950X reader.
Serial Configuration
By connecting the BC9xx0 to a PC through an RS-232 or USB-COM interface
cable it is possible to send configuration strings from the PC to BC9xx0.
Configuration Bar Codes
Link the cradle and the reader using the procedures described in the Power-
Scan PM950X or PBT950X Quick Reference. Once the pairing is complete,
you can configure the BC9xx0 cradle by reading configuration bar codes in
this manual.
To configure the BC9xx0 using the PowerScan 950X reader (paired to the
cradle with the Bind command), follow the procedure according to the inter-
face selected.

Interface Selection

Upon completing the physical connection between the reader and its host,
proceed to
nected to (for example: RS-232, Keyboard Wedge, USB, etc.). Scan the
appropriate bar code in that section to configure your system's correct
interface type.

Setting the Interface

Scan the programming bar code from this section which selects the appro-
priate interface type matching the system the reader will be connected to.
Next, proceed to the corresponding section in this manual (also listed in
Table 2 on page
ated with that interface.
14
™
software configuration program, by sending configura-
Table 2 on page 15
15) to configure any desired settings and features associ-
Unlike some programming features and options, interface selections
require that you scan only one programming bar code label. DO NOT scan an
ENTER/EXIT bar code prior to scanning an interface selection bar code.
Some interfaces require the scanner to start in the disabled state when
powered up. If additional scanner configuration is desired while in this
state, pull the trigger and hold it for five seconds. The scanner will change to
a state that allows programming with bar codes.
to select the interface type the reader is con-
PowerScan™ PD953X/PBT950X/PM950X