Enter/Exit Programming Mode
ADDITIONAL FEATURES FOR 16-KEY MODELS
See also
Last Code Shown Timeout
After the CODE transmission, the last code read will be shown on the display
for a configurable timeout (LAST CODE SHOWN TOUT). .
$CDIST
Last Code Shown Timeout
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
Display Time Stamping Mode
Time Stamping Mode can be applied when entering data from either a bar-
code, from the keyboard, or both.
$CDITS00\r
Applied to both
$CDITS02\r
Applied only to keyboard data
258
"Function Keys Configuration (16-key models only)"
The standard DISPLAY OFF TIMEOUT (see
ority than the LAST CODE SHOWN TOUT, so the two parameters should
be combined to get the desired result.
page 246
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by 2 digits (00-63 by 01) from the
Alphanumeric characters in
End by scanning the ENTER/EXIT bar code again.
~
CANCEL
DEFAULT
$CDITS01\r
Applied only to barcode data
PowerScan™ PD953X/PBT950X/PM950X
on page 253.
) has a higher pri-
Appendix D, Keypad.