Bluetooth Friendly Name; Bluetooth Reconnect Attempt Mode - Datalogic PowerScan 9501-AR Series Product Reference Manual

Bluetooth Friendly Name

You can set a meaningful name for PowerScan BT9501-AR that will appear
in the application during device discovery.
To set a new Bluetooth Friendly Name, scan the barcode below and follow
the instructions.
Set Bluetooth Friendly Name
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.

Bluetooth Reconnect Attempt Mode

Enable/Disable reconnection by trigger pull.
Bluetooth Reconnect Attempt Mode = Enable
Product Reference Guide
POWERSCAN BT9501-AR
DEFAULT
[SERIAL_NUMBER_SCANNER]
Enter/Exit Programming Mode
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by a maximum 64 digits from
the Alphanumeric characters in
Keypad
. The digits must be the hexadecimal ASCII
representation of the desired characters. If less than
the expected string of 32 characters are selected,
scan the ENTER/EXIT bar code to terminate the
string.
CANCEL
Bluetooth Reconnect Attempt Mode = Disable
DEFAULT
Appendix D,
233