Advertisement
5. Inspection / maintenance / adjustment
5.1 Oil inspection / replacement / lubrication
1) Refer to the hour meter display on this product's for guidelines on inspection, replacement,
and lubrication of oil in each part.
2) Oil is filled in the machine at the time of shipment, but before using this machine for the
first time, check again that the specified amount of oil is in the place before using.
3) Regular oil changes are necessary to ensure the machine is always in best condition.
4) When inspecting or replacing each part, be sure to place it on a flat and wide area to
warm up the engine, stop it, and wait for the temperature of each part to drop (about 5
minutes).
...If you work immediately after stopping the engine....
※Engine parts are extremely hot and there is a risk of burns.
※Immediately after the engine is stopped, oil remains in the engine and various parts
of the transmission, and the exact amount of oil is not indicated.
5) For your safety, remove the key and keep it with the owner until the work is finished.
5.1.1 Inspection and replacement of mission oil
Mission plug
Drain Plug
◎ Inspection / supply...
① For inspection, please confirm by removing the Mission
plug at the rear of the mission case. If the mission oil
can be visually confirmed through the Mission plug port
(up to the full lubrication port), the prescribed amount
of mission oil is contained.
HST unit
◎
xchanging
E
② For Exchange , prepare an sutable container to receive
the oil, remove the drain plug (oil drain plug) on the
lower left side of the mission case , after 20 hours used
for the first time and 100 hours each after that.
First time: 20 hours, second time and thereafter: every 100 hours
- 35 -
strictly observe the amount of oil
Guidelines for Exchange
5. 点検・整備・調整
Advertisement
