Advertisement
Closed
Caution
1) Please be careful as the Blade rotates at high speed.
2) Operate the Blade clutch lever slowly.
3) If the Blade clutch lever is suddenly set to the "ON" position at the lowest cutting height position,
the cutting belt will be damaged early due to a sudden overload.
4) When disengaging the Blade clutch, be sure to return the Blade clutch lever to the "disengaged"
position, wait a few seconds (about 5 seconds), and then move up the cutting height adjustment
lever to the "move" position. The Blade may be rotating, which may cause foreign objects such as
stones to scatter. Please be careful.
5) Do not Pile grass or leaves on the engine. Accumulation of these combustible materials may cause
fire or malfunction.
6) If the amount of grass is large and Engine stall frequently, reduce the working speed or increase
the cutting height and cut in several times.
① Keep the knife replacement cover on the right side of this
product closed when operating the mowing work.
② Start the engine.
〈4.1.1Refer to How to start the engine〉
③ Turn the throttle lever to the high speed position and
increase the engine speed.
First, adjust the cutting height adjustment lever to
④
a cutting height position of about 70 mm. Adjust the lever
position by referring to the scale display.
〈2.2 See Functions of each part ⑤ Cutting height adjusting lever
(stepless with assist)〉
⑤
Then slowly tilt the Blade clutch lever to the "ON"
position.
⑥
Fine-adjusting the cutting height adjustment lever
again to the required cutting height.
⑦
Start the machine by referring to
⑧
To finish the work, reverse the above operation
procedure.
⑨ Stop the engine.
〈4.1.2Refer to How to stop the engine〉
- 33 -
<4.2.1 How to drive>.
7. 点検表
Advertisement
