Advertisement
Reference;
Adjust the play at the lever base is about 1 to 3 mm when the differential lock lever is in
the "OFF" position (released). Be sure to securely tighten the lock nut after each adjustment.
⑨Safety switch adjustment.
Switch ON 3〜5mm
the safety switch.
1) 1) If the engine does not start even though you are sitting on the seat and the cutting
height adjustment lever is set to "move" and the parking brake pedal is also locked, adjust
the safety switch. The safety switch operates when the tip of the switch is pushed in the
range of 3.0 to 5.0 mm, and if the tip of the switch is pushed outside the range, the
engine will not start. Adjust the safety switch with reference to the above figure, as the
switch itself may be damaged if it is pushed too far.
2) The safety switch under the seat may not be pushed in normally depending on the
usage conditions.
In that case, adjust it individually using the long hole of the sheet switch stay.
① Safety switches are located on the right side under the
seat bracket, the base of the cutting height adjustment
lever, and the bottom of the seat total three position.
② After adjusting the safety switch, tighten the lock nut and
return the seat to its original position.
④
Check the operation of the tip of the safety switch, and
if the movement is slow, apply a thin layer of grease spray to
the switch operating section. If it does not improve, replace
Individually adjusted with the long hole of the seat switch stay.
- 48 -
5. 点検・整備・調整
Advertisement
