Advertisement
2.2 Function of each part
①Engine switch
Insert the key and operate "START", "RUN", and "Stop" of the engine.
②Thottle Lever
Adjust the engine speed from "Low speed" to "High speed".
③Choke lever
Used to start the engine in cold weather. If you pull it "closed"
"Open" if returned
④Light Switch
Press to turn on (ON, light lit), press again to turn off (light off). When the switch is "ON",
the switch lights blue.
This light is for Moving. Never use it for work. There is a risk of collision, falling, etc. because
the surrounding situation cannot be grasped. Please drive at low speed when the light is on.
⑤Cutting Height Adjustment Lever (Stepless with assistance)
This product can be set to any cutting height between 10 and 80 mm. Press the cutting height
lock button at the tip of the cutting height adjustment lever with your thumb, adjust it to the
desired height and release the lock button to fix the cutting height at that position (see the
figure below). As a guide for cutting height during adjustment, align the lever position with
the scale label on the right side of the lever. The engine will not start except in the "move"
position (maximum pulled up position). The Blade cut height is different when the Blade is
rotating and when it is stopped. The scale is the value when the Blade is rotating in the test
field. Please refer to it as the cutting height during actual mowing work（It depends on the
working environment.）
Adjust the cutting height by pushing the lock button firmly to the end. If you stop the
operation halfway (press halfway), it may cause a malfunction. For safety, be sure to set the
cutting height adjustment lever to the "move" position when entering, leaving, or moving
backward in the work field.
position.
No action required if engine is warm.。
- 15 -
2.各部の名称とはたらき
position、
Advertisement
