Adjusting The Handle And Seat Position; How To Use The Moving Light - OREC RM983F 4WD Operation Manual

4.5

Adjusting the handle and seat position to suit your work and physique

Fixing bolt

and seat suspension function)〉

②

Handle Up & Down

When adjusting the handle height, remove the fixing bolt, adjust the handle height,

insert the fixing bolt, and then fix with the U nut.

③ Handle tilt

The front and rear (tilt) position of the handle can be adjusted forward and backward

Light Switch

particularly low speed when moving during twilight.

●The handle can be adjusted in three stages up and down

also can be adjust front and rear (tilt). The seat can be slid

forward and backward.

① Seat position

The seat position can be adjusted back and forth by pulling

the lever and sliding according to the physique of the

U Nut

operator.

〈2.2 Functions of each part ⑫ See seat (with seat slide

〈2.2 Functions of each part ⑬ Handle Refer to tilt lock lever〉

The light switch is on the lower right side of the handle.

Press to "ON" and press again to "OFF" position.

When "ON", the switch lights blue.

This light is for Driving. Do not use it for work.

In an environment where it is difficult to grasp the

surrounding situation, there is a danger of collisions, falls,

falls, and death, which is dangerous. Also, please drive at a

- 35 -

7. 点検表

Table of Contents