Advertisement
Fuel Cock
House Clip
Ａ
③ Change the engine oil.
④
Thoroughly clean all parts. Especially, the grass and dust accumulated around the rotating
screen, exhaust system, air cleaner, muffler, HST fan cover, carburetor and belt cover are
thoroughly removed by air blowing.
anti-corrosion paint.
⑤ Grease and lubricate the greasing and lubrication points respectively.
⑤
Engage the parking brake and store the machine Flat place in a well ventilated, dry place.
⑥ Check the Engine and Mufffler was cooled down when you will put the cover on the machine.
Also, periodically check the air pressure during storage and add air if necessary.
Reference︔
1) If you start the work with grass and dust accumulated, the engine will overheat due to
clogging with grass chips, which may cause burns or a fire.
2) The blade cover debris can be easily washed away before it dries by washing it with water
pressurized with a hose.
the engine, the carburetor, the air cleaner, and the muffler exhaust port with a cover to
prevent water from splashing.
①
When the machine is not used for more than 30 days,
first remove the fuel in the fuel tank from the fuel filler
into the container with a pump. Remove the remaining
fuel by shifting the fuel hose clip on the tank side of the
fuel cock and removing the remaining fuel in to the
container B. Next, loosen the drain bolt A of the
carburetor with a screwdriver, discharge the fuel in the
carburetor to the container B, transfer all the fuel to the
Ｂ
designated container, and store it in a dry place.
②
Clean the engine and the outer surface of this machine.
(Reinstall the removed parts as before.)
Remove the rust from the rusted parts and apply
At this time, be careful to cover the electrical components of
It may cause engine start failure.
- 55 -
5. 点検・整備・調整
Advertisement
