Error Recovery - Ricoh Gestetner LANIER SAVIN G071 Service Manual

UPGRADING SOFTWARE

Error Recovery

Installation Error
If the software upgrade is unsuccessful, "NG!" or "ERR" appears on the operation
panel. When either of the messages is output, do the following:
1) Turn the main switch off.
2) Check that the IC card is correctly inserted.
3) Turn the main switch on.
4) Start upgrading software from the beginning.
Power Failure
If the power supply is interrupted, an error code may appear on the operation panel.
Then, do the following:
1) Turn the main switch off.
2) Failure during BCU firmware download: Turn DIP switch 1 on the BCU board
to ON
Failure during controller, emulation, or network firmware download: Turn DIP
switch 1 on the controller board to ON
3) Turn the main switch on.
4) Start upgrading software from the beginning.
5) Turn the DIP switch off again after finishing.
G071
CÓPIA NÃO CONTROLADA
5-58
CÓPIA NÃO CONTROLADA
Rev. 04/2003
SM