Development Unit - Ricoh Gestetner LANIER SAVIN G071 Service Manual

3.6 DEVELOPMENT UNIT


CAUTION
Do not touch the development unit sleeves or ID chip terminals.
1. Open the left cover [A].
2. ID chip connector [B]
3. Lift up the development unit [C]
slightly, and pull it out of the
machine.
NOTE: Remove the units in the
order K, Y, C, M. For
example, before removing
the M unit, remove the K, Y,
and C units first.
4. Peel off the toner cartridge seal [D].
5. Reinstall the toner cartridge in the
development unit.
6. Keep the development unit level and
shake the development unit about 10
times from side to side.
NOTE: 1) Do not touch the
development roller or the
development roller gear.
2) Use caution not to drop the
cartridge or to damage it.
3) If the cartridge has not been
shaken well, the machine
takes a longer time to
initialize the development
unit, or an error message or
SC350 is displayed. When
either of them is displayed,
turn the main switch off and
on.
SM
CÓPIA NÃO CONTROLADA
[B]
[C]
3-17
CÓPIA NÃO CONTROLADA
DEVELOPMENT UNIT
[A]
G070R301.WMF
[D]
G070R901.WMF
G070R902.WMF
G071