Stapling Mode - Ricoh Gestetner LANIER SAVIN G071 Service Manual

Stapling Mode

[B]
[G]
G314D106.WMF
[F]
G314D114.WMF
The stapler is attached to the jogger tray, so all sets go to the jogger tray.
After all pages of a set have entered the jogger tray and been shifted across, the
paper exit link [A] pulls the paper exit unit [B] down until knob [C] on the exit unit
pushes the link lever [D] for the exit unit switch [E]. This turns on the exit unit switch.
When this switch is on, dc is supplied to the stapler unit [F] and the main motor is
turned off.
The exit unit switch is activated when the exit unit is pulled part-way down. After
stapling the set of prints, the paper exit unit is pulled down again until the unit
comes in contact with the paper exit roller [G], and the stapled set is fed out.
SM
CÓPIA NÃO CONTROLADA
[A]
[D]
[E]
19
CÓPIA NÃO CONTROLADA
DETAILED SECTION DESCRIPTIONS
[B]
[C]
G314D112.WMF
G314