Ricoh Gestetner LANIER SAVIN G071 Service Manual page 108

SP MODE TABLES
9. Use the up/down arrow key to select the setting you are adjusting, then press
the enter key. The three digits in the display (example '016') indicate a position
on the color calibration test sheet.
Operation Panel
Display
Set Black 1
Set Black 2
Set Black 3
:
:
Set Black 13
Set Black 14
Set Black 15
Set Cyan 1 ~ 15
Set Magenta 1 ~ 15
Set Yellow 1 ~ 15
Adjust the color density at each of the 15 points for each of the four colors.
NOTE: 1) To decide what density value to input, do the following.
2) Look at the color adjustment sheet.
3) For the color you are adjusting, look at the gradation scale entitled
'Default'.
4) Go along the scale until you reach the density that you wish to input.
5) Read off the value on the scale and store it in the machine.
a) Use the up/down key to move the cursor along the three-digit
display, then press the Enter key.
b) Use the up/down key to change the digit at the cursor, then press
the Enter key.
c) Press the Escape key to exit from the menu.
6) Do the same for all 15 points.
10. When the density setting is complete for all colors, print out a color adjustment
sheet again and make sure that the gradation scale for each printed color is
smooth and that the CMY gradation scale is gray. Repeat the adjustment if
there is an anomaly (normally, repeat this procedure 3 to 5 times).
11. When the adjustment results are satisfactory, do the following:
1) Use "ToneCtlSave" in the controller service menu, to store the new settings
in the controller.
2) Reset the controller (press the [Reset] key when the machine is off line") to
use the new settings.
NOTE: The new settings will not be saved in the controller NVRAM unless you
reset the controller.
G071
CÓPIA NÃO CONTROLADA
Color Calibration
Test Sheet
Default Value 16
Default Value 32
Default Value 48
:
:
Default Value 208
Default Value 224
Default Value 240
See Set Black 1 ~ 15
See Set Black 1 ~ 15
See Set Black 1 ~ 15
5-10
CÓPIA NÃO CONTROLADA
SM