166: Attribute Select Keyboard (Configuration Support C Only); 170: Distributed Function Terminals (Configuration Support T Only) - IBM 3270 Manual

u
166: Attribute Select Keyboard (Configuration Support C Only)
Note: This sequence number will not be asked unless you specified a 1 for
sequence number 131 (typewriter keyboard) or 134 (APL keyboard).
For examples of the attribute select keyboards, see Figures M-6 through
M-8 in Appendix M.
Enter one of the following to specify whether an attribute select typewriter
keyboard (feature 4651), an attribute select typewriter/APL keyboard
(feature 4652), or a typewriter overlay keyboard (feature 4640) is being used:
A None of these keyboards is being used.
B One or more of these keyboards are being used, but you do not wish
to use the numeric lock function on any of them.
C One or more of these keyboards are being used, and you wish to use
the numeric lock function on all of them.
170: Distributed Function Terminals (Configuration Support T Only)
0 = No distributed function terminals are attached.
1
=
Distributed function terminals that require a load diskette will be
attached, or a combination of distributed function terminals that
require a load diskette and those that do not require a load diskette
will be attached.
2 = Only distributed function terminals that do not require a load diskette
will be attached.
Notes:
1. If your response is 0, sequence numbers 171 through 176 are not
displayed.
2. If your response is 2, respond to sequence numbers 139, 173, and 175 with
O's.
Chapter 3. Preparing to Customize
3-49