IBM 3270 Manual page 277

K-4
Example B
128
Fl - QOOOOOOO
Bl - 00
B2 - 00
B3 - 00
B4 - 00
01
02
05
10
0
0
0
0
x ... x
904 - 0
The panel of Example B is not displayed unless the first digit response to
sequence number 127 was a 3, 4, or 5.
The initial values shown in the Fl and Bl through B4 fields are the default
values for those fields and will be present when the panel is first displayed.
The cursor i~ initially positioned as shown in each example.
Sequence number 128 fields and responses are as follows:
x ... x
Fl
is the model number field: This field is
not
defined during
customization but will show the control unit address, model
number, and, if appropriate, the communication mode being
used (SDLC or BSC). The BSC or SDLC address is picked up
from sequence number
301
or
302,
as appropriate.
is the host interface status field. If displayed an eight digit
response is required. Valid digits are 0 and 1 and carry the
following meaning:
A 0 turns off the function associated with the digit position
A 1 turns on the function associated with the digit position
Function and digit position are related as follows:
xxxxxxxx
_ _ _ ......._ __ RTM data collection on or off. The default is
off, and RTM will remain off unless turned
on by host support.
l...of-...__--'---
The
327 4
will transmit unsolicited RTM logs
when an UNBIND is processed (LU-LU
session).
'--1----'--The
3274
will transmit unsolicited RTM logs
when a counter overflow occurs.
'----'---- RTM will send a delayed alert message when
the
3274
is re-IMLed based on the contents of
a problem determination register in the RTM
timer card.
Reserved. Set to 0.