IBM 3270 Manual page 114

u
(u·,
\
Initial Customizing Procedure Form
Validation Number 10
Review this entire form before starting the customizing procedure. Display
station operating procedures are described in the
Operator's Guide
for the
display station to be used in customizing.
This procedure configures the 3274 Control Unit.
If you do not get the
expected result in any step, start over at step 1. If you still do not get the
expected result, report the problem.
There are four indicators; labeled 8 4 2 1, on the 3274 control panel. The
meanings of the 8 4 2 1 indicator codes are shown in Figures 4-5 and 4-6.
If an error occurs during this procedure, the 8 4 2 1 indicator code may
help you locate the cause. Within this form, an on indicator is called a 1,
an off indicator a 0 (zero). Example: a
4 2 1
3274 Control Panel
Alt IML
Address
1
2
8 4 2 1
0 0 0 0
IML
* *
0
*=1101
I
0
Local/Offline
indicator
On
indicator
On
Off
IM L pushbutton
This rotary switch is on Models 1 A, 1 B, 1 D,
21A, 21 B, 21 D, 31 A, and 31 D only.
Type of keyboard to be used:
D
Typewriter
D
Data Entry Keypunch
D
Data Entry
D
Japanese Katakana Typewriter
D
Japanese Katakana Data Entry
D
Japanese English Typewriter
Du ring customizing, only certain keys are active. Turn to Figures 4-1 and
4-2, following this form, to see which keys on your keyboard can be used
for customizing. '
1. Obtain the:
Feature diskette
System diskette
Language diskette (if applicable)
Load diskette (if applicable)
RPO diskette(s) (if applicable)
- - - - - -
- - - - - -
1. _ _ _ _ _ _
2. _ _ _ _ _ _
3. _ _ _ _ _ _
)
These diskettes
were delivered
with the 3274.
2. Ensure that the 3274 Control Unit and the display station have power
switched on. The display station must have a keyboard and must be
attached to port AO of the 327 4.
Note: When customizing a 3274 Model 1A, 1 B, 1 D, 21A, 21 B, 21 D, 31A,
or 31 D, do not set the on/off switch to the off position unless the rotary
switch on the control panel is in the Local/Off line position and the Local/
Offline indicator is on. The Power/Interface switch must be in the Local/
Offline position and the Local/Offline indicator must be on.
Chapter 4. Initial Customizing Procedure
4-3