IBM 3270 Manual page 115

4-4
3. Insert the feature diskette (Figure,4~3); GJri~ press the IML pushbutton
momentarily. Within 1 minute, the 8 4 2 1 indicator code should be
0001. If you are usihg a 3279
Colo~
Display Station, refer to Appendix
1
\_...!
E for the convergence procedure.
4. Look for a 3-digit sequence !lumper i.n the upper left corner of the screen.
The first one is 001. Beneath the sequence number are Xs, which you
replace by typing in the respqnse to sequence number 001 (below). If the
response you enter is acceptable, a new sequence number will be displayed.
If the response is unacc::eptable, a 2-digit operator code· will be displayed
in the upper center portion of the screen. See Figure 4-4 for the meaning
of th is code.
If you are using a 3179 display Station, it must be operating in 3279-
emulation mode. If you are using a 3180 .display station, it must be
operating in 3278-emulatjon mode. If your 3179 or 3180 is not in
emulation mode (that
is~
if it is in native mode), the riumber 212 will
appear in the operator information area of the display screen when the
first keystroke is attempted and customizing cannot proceed.
Sequence Number 2-Digit Operator Code
Response
xx xxxx
Cursor _ _ _ XXXXXXXXXXXXXXXXXXX
Ignore these numbers
if they are displayed
Operator
- Information
Area
Note: If a 76- or 88.,key Japanese English or Japanese Katakana keyboard
is used, press the key circled in Figure 4-2 before proceeding. The
keybqard wilJ be locked for about 10 seconds. When the keyboard
unlocks,· coflti nue.
• Type in the following characters in response
fo
sequence number 001:
1234567890ABCD E F
• Press the .spacebar once.
• Type in the 2-digit validation number that is printed on the first page
of this form.
• Press ENTER.
Note: Use only the cursor move keys or tab key to reposition the cursor.
5. Type in a 0 {zero) in response to sequence numb.er 011. Press ENTER.
6. If yo~ have
not
been given a Printer Auth'orization Matrix Form, type in a
0 in response to sequence number 021 ahd press ENTER. If you have ,
been given the Printer Authorization Matrix Form, type in a 1 and press 1
0
ENTER; then follow the instructions on the form.