IBM 3270 Manual page 112

( i
'\._)
Chapter 4. Initial Customizing
Proced~re
This chapter contains a recommended
Ini~ial
Customizing Procedure Form.
This form should be used the first time
th~
3274
Control Unit is customized.
Once the 327 4 is successfully customized,
if
changes are requirnd
o:r d~sire_d, . __
the Modification Procedure Form might b~ useful. See Chapter 5 for
specifics.
The information on the Initial Customizin
1 g
Procedure Form should be
. ' I , . • ,
copied onto the IBM 327 4 Configuration
~ata
Card (Configuration Support:
A, B, C, T), GA23-0046, supplied with the r274. A copy of this card is
included at the end of this cliapter. The cfird should be stored, for future
reference, in the diskette storage area of the 327 4.
The planner should enter the following information on the Initial
I
Customizing Procedure Form:
1.
The type of keyboard (typewriter or da'.ta entry) to be used by the
I
operator. '
Note: If using a 76- or 88-key Japanese English or Japanese Katakana
keyboard, specify the number of keys
~nd
the keyboard type.
2. In step 1, the identification of each dis;
1
kette to be used.
3. In step 7, the response to sequence nu:rhber 031 (number of RPQ
diskettes to be used).
If
you have no RPQ diskettes, the response is 0.
If your response to sequence number 0$1 is not 0, you may have to enter
a response to sequence number 032.
S~e
"032 (Request RPQ Parameter
List)" in Chapter 3.
4.
In step 8, the responses to be entered
~Y
the operator, using as a guide
the section in Chapter 3 that applies t~ the model being customized.
Fill in the boxes that apply to your configuration support.
In addition to the Initial Customizing Procedure Form, this chapter
contains:
8 Keyboard diagrams showing the valid key positions for customizing
(Figures 4-1 and 4-2).
e
A diagram showing how to insert a dis;kette properly into the 327 4
Control Unit (Figure 4-3).
Chapler 4. Initial Customizing Procedure
4-1