Composite Scissor Lock; Adjusting; Replacing; Uni-Lock - Permobil Aero Z 2 Series Owner's Manual

CHAPTER 10: WHEEL LOCKS

Composite Scissor Lock

Adjusting

Tools Needed:
• 5 mm Allen Wrench
1. Loosen, but do not remove, the Allen screws in the wheel lock clamp. See Figure 10-3.
2. Adjust the position of the wheel lock clamp on the frame so the wheel stop embeds at least 5 mm into the tire when
engaged in the locked position.
3. Securely tighten the two Allen screws that secure the wheel lock clamp to the frame.

Replacing

Tools Needed:
• 5 mm Allen Wrench
1. Loosen, but do not remove, the two Allen screws that secure the wheel lock clamp to the frame. See Figure 10-3.
2. Slide the wheel lock out of the clamp.
3. Slide the new wheel lock into the wheel lock clamp, but do not tighten the Allen screws.
4. Follow the procedures under "Composite Scissor Lock - Adjusting" on page 10-2 to position and secure the new
wheel lock.

Uni-Lock

Adjusting
Tools Needed:
• 5 mm Allen Wrench
1. Loosen, but do not remove, the two Allen screws in the wheel lock clamp. See Figure 10-4.
2. Adjust the position of the wheel lock clamp on the frame so the wheel stop embeds at least 5 mm into the tire when
engaged in the locked position.
3. Securely tighten the two Allen screws that secure the wheel lock clamp to the frame.
Permobil Aero Z & ZRA Owner's Manual
Figure 10-3
Adjusting/Replacing the Scissor Lock
Wheel Lock
Clamp
Tire
Wheel Stop
Allen
Screws
Frame
10-3 OM0004-ENGLISH_Rev E_Aero Z_ZRA