Adjusting The Armrest Angle - Permobil Aero Z 2 Series Owner's Manual

CHAPTER 5: ARMRESTS

Adjusting the Armrest Angle

Tools Needed:
• 4 mm Allen Wrench
1. To adjust the angle at which the armrest sits when in the down position, loosen, but do not remove, the Allen screw
that secures the stop clamp. See Figure 5-8.
2. Slide the stop clamp forward on the armrest to lower the angle at which the armrest sits in the down position, or slide
the stop clamp rearward on the armrest to raise the angle.
3. Securely tighten the Allen screw to fix the stop clamp in place.
I WARNING
Make sure that the stop clamp is securely tightened before applying weight to the armrest.
If you ignore this Warning, you could fall, tip over or lose control of the wheelchair and seriously injure yourself or others
or damage the wheelchair.
Permobil Aero Z & ZRA Owner's Manual
Figure 5-8
Adjusting the Armrest Angle
Stop
Clamp
Allen
Screw
5-5 OM0004-ENGLISH_Rev E_Aero Z_ZRA