Adjusting The Height/Replacing; Angle Adjustable High Mount Footrest; Adjusting The Angle - Permobil Aero Z 2 Series Owner's Manual

Adjusting the Height/Replacing

The Angle Adjustable Footrest can be replaced or the height adjusted by using the tools and following the procedures under
"Titanium Footrest with Flat ABS Cover - Adjusting the Height/Replacing" on page 3-2.

Angle Adjustable High Mount Footrest

Adjusting the Angle

Tools needed:
• 4 mm Allen Wrench (no high mount extension tubes)
• 5 mm Allen Wrench (high mount extension tubes only)
1. Loosen, but do not remove, the two Allen screws that secure the footplate to the clamp. See Figure 3-7. If your footrest
has extension tubes (see Figure 3-8), you will have 5 mm Allen screws in place of locknuts and you will only need
to loosen these latter Allen screws to adjust the angle.
2. Adjust the footrest to the desired angle.
3. Tighten the Allen screws and locknuts (or 5 mm Allen screws), making sure the screws and the locknuts (or 5 mm
Allen screws) are secure and will not permit the footplate to rotate up or down under weight.
Figure 3-7
Angle Adjustable High Mount Footrest
Allen
Screws
Permobil Aero Z & ZRA Owner's Manual
Figure 3-6
Adjusting the Angle
Allen
Screws
Footplate
Angle Adjustable High Mount Footrest with Extension Tubes
Locknuts
3-4
CHAPTER 3: FOOTRESTS
Washers
Clamp
Locknuts
Figure 3-8
Extension Tubes
Allen Screws
OM0004-ENGLISH_Rev E_Aero Z_ZRA