Removing; Reinstalling; Fold-Down Rigid Side Guards (Aluminum And Carbon Fiber); Using Fold-Down Side Guards - Permobil Aero Z 2 Series Owner's Manual

Removing

Tools Needed:
• 5 mm Allen Wrench
To remove the entire side guard assembly, including the clamp:
1. Remove the side guard from the side guard mount.
2. Remove the Allen screw that secures the two halves of the clamp to the frame. See Figure 6-2.

Reinstalling

Tools Needed:
• 5 mm Allen Wrench
1. Align the two halves of the clamp around the seat tube of the chair frame. See Figure 6-2.
Note: The half of the clamp to which the side guard mount is attached has a dowel pin protruding from the clamp that
must be inserted in the clamp hole in the frame.
2. Insert the Allen screw through the washer, the two halves of the clamp and securely tighten.
3. Insert the side guard bracket into the side guard mount and adjust the two Allen screws as described under "Adjusting"
on page 6-1.

Fold-Down Rigid Side Guards (Aluminum and Carbon Fiber)

Using Fold-Down Side Guards

To fold down, simply remove the seat cushion and push the top of the side guard toward the seat sling. To unfold, simply pull
the side guard up away from the seat sling. See Figure 6-3.
Removing
Tools Needed:
• 5 mm Allen Wrench
1. Remove the two Allen screws that secure the two halves of the side guard clamp. See Figure 6-3.
2. Remove the Fold-Down Side Guard clamp assembly.
Permobil Aero Z & ZRA Owner's Manual
Figure 6-3
Removing/Reinstalling
Dowel
Pin
Clamp
6-2
CHAPTER 6: SIDE GUARDS
Allen
Screws
OM0004-ENGLISH_Rev E_Aero Z_ZRA