Adjusting The Height; Desk Arm With Rigid Side Guard And Desk Arm With Rigid Side Guard And Transfer Loop; Adjusting The Armrest Height; Removing - Permobil Aero Z 2 Series Owner's Manual

Adjusting the Height

Tools Needed:
• 4 mm Allen Wrench
1. Remove the armrest from the receiver.
2. Remove the Allen screw and washer securing the
armrest stop. See Figure 5-3.
3. Reassemble the armrest stop in the desired location
on the armrest (in 19 mm increments).
4. Securely tighten the Allen screw.
5. Reinstall the armrest in the receiver.

Desk Arm with Rigid Side Guard and Desk Arm with Rigid Side Guard and Transfer Loop

I WARNING
Make sure the armrest is securely engaged in the desk arm housing (see Figure 5-4), before applying weight to the armrest.
If you ignore this Warning, you could fall, tip over or lose control of the wheelchair and seriously injure yourself or others
or damage the wheelchair.
Note: Never lift your chair using the desk arm mount. See Figure 5-5.

Adjusting the Armrest Height

1. Remove the height adjustment screw to permit the armrest to be raised or lowered to the desired height. See Figure 5-4.
2. After repositioning the armrest to the desired height, reinstall and securly tighten the height adjustment screw to lock the
armrest in that position. The positioning holes are in 13 mm increments.

Removing

1. To remove the desk arm assembly, press and hold the release lever. See Figure 5-4.
2. While holding the release lever, lift the desk arm assembly to remove it from the desk arm mount. See Figure 5-5.

Replacing

Slide the desk arm housing into the desk arm mount. See Figure 5-5.
Permobil Aero Z & ZRA Owner's Manual
CHAPTER 5: ARMRESTS
Figure 5-3
Adjusting the Height
Allen Screw
5-2
Armrest
Washer
Armrest
Stop
Receiver
OM0004-ENGLISH_Rev E_Aero Z_ZRA