Wheel Lock Release; Plastic Rail - Permobil C300 Service Manual

Wheel Lock Release

Wheel Lock Release
The wheel lock release consists of a plastic rail, a
wheel lock release sensor and a magnetic wheel
lock on each drive motor.
Removing the Plastic Rail
1. Raise the seat; seat elevator to the highest
position; fixed seat tube to the service position.
See page 24. If the seat elevator does not
work normally because the batteries are
discharged or the actuator is defective, the
seat can be raised/lowered
See page 22.
2. Switch off the main power switch on the control
panel.
3. Remove the chassis cover. See page 7.
4. Remove the wheel lock release sensor,
see page 20.
NOTE
Before removing the plastic rail, make sure the wheel lock
release sensor is removed.
5. If the wheel lock release arm is moved
backwards on the left magnetic wheel lock, the
plastic rail can be pulled out of the chassis.
Fitting the Plastic Rail
NOTE
Before inserting the plastic rail, make sure the wheel lock
release sensor is removed.
1. Insert the plastic rail on the right side of the
chassis.
2. Check that the rail is correctly located by the
wheel lock release sensor. See figure.
3. Push the rail in further so that its end emerges
on the left side of the chassis.
4. If the wheel lock release arm is moved
backwards on the left magnetic wheel lock,
the plastic rail can be moved into place.
5. Refit the wheel lock release sencor, see
page 20.
6. Refit the chassis cover. See page 7.
7. Lower the seat to its normal height.
manually.
If the wheel lock release arm is moved
backwards on the left magnetic wheel lock,
the plastic rail can be pulled out of the chassis.
18
Wheel lock release sensor.
Wheel lock release