Reinstalling; Fendered Carbon Fiber Side Guard; Using Fendered Side Guards; Adjustable Fendered Side Guard (Aluminum) - Permobil Aero Z 2 Series Owner's Manual

CHAPTER 6: SIDE GUARDS

Reinstalling

Tools Needed:
• 5 mm Allen Wrench
1. Align the two halves of the side guard clamp around the seat tube of the frame. See Figure 6-3.
Note: The half of the side guard clamp to which the side guard mount is attached has a dowel pin protruding from
the clamp that must be inserted into the side guard clamp hole on the wheel side of the frame.
2. Insert the two Allen screws through the washers and the two halves of the clamp and securely tighten.

Fendered Carbon Fiber Side Guard

Using Fendered Side Guards

To remove the Fendered Side Guard, lift the side guard out of the side guard mount. To replace, place the bracket into the
slot between the side guard mount and the clamp. Make sure the rearward end of the side guard is inside the stabilizer tab.
See Figure 6-4.
To adjust the fendered side guards, see "Adjusting" on page 6-1.

ADJUSTABLE FENDERED SIDE GUARD (Aluminum)

Mounting

Tools Needed:
• 2.5 mm Allen Wrench
• 4 mm Allen Wrench
• 10 mm Openend Wrench
Note: You may need to adjust the Tension Adjustable Seat Sling to gain access to the seat tube placement you desire.
If this is necessary, see "Adjusting the Tension" on pages 7-3 and 7-4.
Permobil Aero Z & ZRA Owner's Manual
Figure 6-4
Fendered Carbon Fiber Side Guard
Stabilizer
Tab
Bracket
6-3
Clamp
Side Guard
Mount
OM0004-ENGLISH_Rev E_Aero Z_ZRA