Adjusting The Center Of Gravity - Permobil Aero Z 2 Series Owner's Manual

Adjusting the Center of Gravity

Tools Needed:
• 5 mm Allen Wrench
• Ruler
1. Loosen, but do not remove, the four Allen screws (two on each side of the chair) that secure the camber mount clamps
to the frame. See Figure 8-2.
2. Slide the camber mount clamps forward or rearward along the frame until it is positioned in the desired location.
Use a ruler to ensure the camber mount assemblies on both sides of the chair are the same distance from the ends
of the frame tubes.
3. Securely tighten the four Allen screws.
4. Check the rear seat height and adjust as needed.
5. Check the toe-in/toe-out and adjust as needed and square the casters as needed. See pages 8-3 and 8-4.
Permobil Aero Z & ZRA Owner's Manual
CHAPTER 8: AXLE PLATES & CAMBER PLUGS
(CENTER OF GRAVITY; REAR SEAT HEIGHT)
Figure 8-1
Adjusting the Rear Seat Height
Vertical Strut
Washer
Allen Screw
Figure 8-2
Adjusting the Center of Gravity
Camber Mount
Clamp
Allen
Screws
8-2
Notches
Camber Tube Clamp
OM0004-ENGLISH_Rev E_Aero Z_ZRA