Slipstream Single-Sided Forks; Replacing Casters; Replacing Forks - Permobil Aero Z 2 Series Owner's Manual

Slipstream Single-Sided Forks

Replacing Casters

Tools Needed:
• 3 mm Allen Wrench
1. Remove the Allen screw and caster cap. See Figures 11-4.
2. Remove the caster.
3. Install the new caster onto the Slipstream Single-Sided Fork, replace the single sided caster cap and securely tighten
the screw so there is no space between the caster and the Slipstream Single-Sided Fork side.
Note: Caster wheel is asymmetrical. Deeper caster side should be outward facing when in the trialing position.

Replacing Forks

Tools Needed:
• 17 mm Socket Wrench
• 3 mm Allen Wrench
1. Remove the casters. See "Slipstream Single-Sided Forks – Replacing Casters" on page 11-4.
2. Remove the nylock nut and washer. See Figure 11-4.
3. Remove the old fork and install the replacement fork on the fork stem.
4. Replace the nylock nut and washer and securely tighten.
5. Reinstall the casters. See "Slipstream Single-Sided Forks – Replacing Casters" on page 11-4.
Permobil Aero Z & ZRA Owner's Manual
CHAPTER 11: CASTERS, FORKS AND CASTER PIN LOCKS
Slipstream Single-Sided Fork
Fork Stem
Fork
Figure 11-4
Caster Cap
Washer
Nylock Nut
Caster
Caster Cap
Allen
Screw
11-4 OM0004-ENGLISH_Rev E_Aero Z_ZRA