Vehicle-Anchored Belts - Permobil Aero Z 2 Series Owner's Manual

CHAPTER 14: TRANSPORTATION OPTIONS
I WARNING
Always ensure that the pelvic and shoulder belt buckles are positioned so that the release buttons will not come into contact
with any other item or by wheelchair components in the event of a vehicle accident or collision.
I WARNING
Always carefully inspect the occupant restraint system belts, brackets and clamps to ensure that they are properly secured
to the vehicle and are not damaged or worn.
WHEELCHAIR-ANCHORED BELTS
1. Install the pelvic belt by securing the Belt Mounting Hardware (see Figure 14-5) to the Belt Pin (see Figure 14-6) on the
Pelvic Belt Mounting Bracket (see Figure 14-6). Pull to ensure that the mounting hardware snaps into place.
2. Repeat Step 1 for the Belt Mounting Hardware on the other end of the Pelvic Belt.
3. Install the vehicle-anchored shoulder belt by connecting it to the Shoulder Belt Pin on the Pelvic Belt. See Figure 14-6.
Wheelchair-Anchored Belt
Shoulder
Belt Pin
Pelvic Belt

VEHICLE-ANCHORED BELTS

In accordance with WC19 Annex C, the Permobil ZRA and Aero Z were evaluated with regard to lateral stability. The test for
lateral stability is shown in Figure 14-7 below. The average test results for point "P" were as follows:
• ZRA 16.4 mm
• Aero Z 17.9 mm
Permobil Aero Z & ZRA Owner's Manual
Figure 14-5
Pelvic Belt
Mounting
Bracket
"Good"
"Good"
Figure 14-6
Wheelchair-Anchored Belt
Pelvic Belt
Mounting
Bracket
Belt Pin
14-7 OM0004-ENGLISH_Rev E_Aero Z_ZRA