Wheel Lock Release Cables - Permobil Chairman 2k Service Manual

Wheel lock release cable
Wheel lock release cable
Removal
1. Run the seat up to its highest position.
See page 7 for instructions to manually raise the seat.
2. Remove the covers, see page 8.
3. Remove the wheel lock release cover, see fig. 16-17.
4. Loosen the locking nut(18:2).
5. Screw the adjustment screw in(18:1) completely.
6. Loosen the cable by the magnetic wheel lock by
drawing the cable sleeve forwards and in front of
the cable through the slot in the cable holder,
unfasten the wheel lock release cable from the
magnetic wheel lock.
7. Loosen the cable at the release lever.
Fitting
1. First mount the cable by the magnetic drum, and
subsequently by the release lever.
2. Adjust the length of the cable sleeve using the
adjusting screw(18:1), so that the wheel lock
realease sensor(18:3) is activated immediately,
before the cable pulls the release arm.
3. Check that the wheel cannot turn round before the
wheel lock realease sensor(18:3) has been
activated.
4. Check that the wheel can be turned when the
wheel lock is disengaged by the release lever.
5. Tighten up the locking nut (18:2).
6. Remount the wheel lock release cover as well as
other covers.
1 2 3
Fig. 18. Mechanism for wheel lock release.
12
Fig. 16. Wheel lock release cover.
Fig. 17. Screws (qty. 2). wheel lock
release cover.