Rear Wheel Spacers; Adjusting The Rear Wheel Spacing - Permobil Aero Z 2 Series Owner's Manual

CHAPTER 12: REAR WHEELS

Rear Wheel Spacers

Adjusting the Rear Wheel Spacing

I WARNING
Make sure you use the same spacers on both sides of the chair. Do not use spacers exceeding a total of 2 cm. If more than
2 cm of the axle sleeve is outside of the camber plug, the axle sleeve could disengage from the camber plug while you are
using the chair.
Tools needed:
• 22 mm Open End Wrench
• Two 19 mm Open End Torque Wrenches
1. Place one of the 22 mm Open End wrench onto the camber plug and use the second 19 mm Open End torque wrench
to remove the axle sleeve. See Figure 12-5.
Note: If you have only one washer and do not have a lock washer, your rear wheel spacing package will include a lock
washer. Always use a lock washer.
2. Add or remove the spacers you need to increase/ decrease your rear wheel spacing, keeping the two washers against
the head of the axle sleeve.
3. After you have adjusted your rear wheel spacing, reinstall the axle sleeve in the camber plug and hand-tighten.
4. Using a torque wrench, tighten the axle sleeve to 26 N-m.
Permobil Aero Z & ZRA Owner's Manual
Figure 12-5
Adjusting the Rear Wheel Spacing
Camber
Tube
13 mm Spacer
6 mm Spacer
12-3
Camber Plug
Washer
Lock Washer
Axle Sleeve
OM0004-ENGLISH_Rev E_Aero Z_ZRA