Swing Away Armrest; Adjusting The Angle - Permobil Aero Z 2 Series Owner's Manual

CHAPTER 5: ARMRESTS

Swing Away Armrest

To swing away the armrest, lift the armrest and rotate the armrest away from chair. See Figure 5-1. Make sure to lift the
armrest until the armrest stop is above the notch on the receiver.
To replace the armrest, rotate the armrest back towards the chair and gently push it down into place. See Figure 5-1.
Make sure the armrest stop is in the notch on the receiver.
Note: The Swing Away Armrests pivot on nylon sleeves, located inside the receiver. If the armrest does not rotate properly,
remove the armrest, clean the armrest and inside the receiver thoroughly. If this does not solve the problem, check the
nylon sleeves for wear.
Armrest Stop
Receiver

Adjusting the Angle

Tools Needed:
• 10 mm Open End Wrench
• 4 mm Allen Wrench
1. Remove the armrest from the receiver.
2. On one side of the chair, loosen, but do not remove,
the nylock nuts while holding the locking block in position
with your finger. See Figure 5-2.
3. To change the angle of the armrest, move the locking block
one or more teeth up or down until the desired armrest angle
is achieved.
4. Make sure the locking block teeth are fully engaged with the
teeth on the receiver, and securely tighten the nylock nuts.
5. Repeat this procedure on the other side of the chair.
Permobil Aero Z & ZRA Owner's Manual
Operating the Swing Away Armrest
Armrest
Notch
Figure 5-1
Locking
Block
5-1
Figure 5-2
Adjusting the Angle
Nylock
Nuts
OM0004-ENGLISH_Rev E_Aero Z_ZRA
Receiver