Table of Contents
Advertisement
Video sources supported by the dual-Base version
The dual-Base version accepts the following video sources for each acquisition
path:
Camera Link Standard
Not Camera Link Standard
Video sources supported by the single-Full version
In addition to the video sources supported by the dual-Base version, the single-Full
version supports the following video sources:
Camera Link Standard
Not Camera Link Standard
ChannelLink receivers
The dual-Base version of the board uses two standard ChannelLink receivers for
video input(s), while the single-Full version uses three. The dual-Base version can
operate the two receivers asynchronously, whereas single-Full version operates
them synchronously.
Each receiver can receive up to 24 bits of video data and 4 bits of synchronization
and field data, as serialized data over four LVDS pairs from the video source. A
clock is received from the video source over a fifth LVDS pair.
Matrox Helios eCL/XCL acquisition section
Video sources supported per acquisition path
• One tap x 8/10/12/14/16-bit.
• Two tap x 8/10/12-bit.
• One 3 x 8-bit (RGB).
• Two tap 14/16-bit with time-multiplexing.
• Four tap 8-bit with time-multiplexing.
Video sources supported
• Eight tap x 8-bit.
• Four tap x 8/10/12-bit.
• One 3 x 10/12-bit (RGB).
• 8 tap x 8-bit with time-multiplexing (using only 2 receivers).
• Four tap 10/12-bit with time-multiplexing.
• Two tap x 14/16-bit.
• One 3 x 14/16-bit (RGB).
• Two 3 x 8-bit (RGB) (genlocked).
51
Advertisement
Table of Contents
