Matrox Helios Series Installation And Hardware Reference page 34

34 Chapter 2: Hardware installation
Internal
Auxiliary I/O
connector
System reset
connector
Camera Link
Video Input
Connector #0
Connector #1
Depending on if you are using the single-Full or dual-Base version of Matrox
Helios eCL/XCL, you can connect one or two video sources to the pair of Camera
Link connectors, respectively. Use standard Camera Link cables. You can purchase
such a cable from your video source manufacturer, 3M Interconnect Solutions for
Factory Automation, Intercon 1, or other third parties. Note that this cable is not
available from Matrox. If using both Camera Link connectors on the single-Full
version of the board, the cables must be of the same type and length.
External
Auxiliary I/O
Connector #0
Connector #1