Table of Contents
Advertisement
7) Release the two hooks @@ and remove the
21. Installing Position for the Cover
caterpillar () from the carriage cover.
Tube
Install the cover tube following the instructions
below.
« Arrange the marked (1) side towards the side
of the caterpillar.
¢ Install the cover tube so that the mark @ of
the cover tube is aligned with the position A.
* Since each colored cover tube has a different
length, don't make any mistake about the
installing position for each colored tube.
* Put the tube onto the joint so that the tube
reaches the end of the joint.
Figure 3-252
8)
Remove the tube joint (2 from the head joint @
and remove the cover tube (Bk).
Figure 3-254
22. Removing the Ink Supply Tube
1) Remove the cover caterpillar unit. (Refer to
page 3-7).
Figure 3-253
2) Release the two hooks @) and remove the
caterpillar @ from the carriage cover.
Figure 3-255
COPYRIGHT © 1998 CANON INC.
3-20
Advertisement
Table of Contents
