Table of Contents
Advertisement
mm CHAPTER 1 GENERAL INTRODUCTION
13) Remove the four butfer electrodes using gloves
in order to prevent ink stains.
\
Buffer electrodes
Figure 1-814
CAUTION
Before handling buffer electrode section,
remove ink bottle case from printer body in
order to prevent damage to ink detection
PCB by static electricity.
Take the greatest care not to touch the
metal part on the buffer electrode.
14) Attach the four buffer caps on the buffer sec-
tion.
Figure 1-815
CAUTION
Before attaching buffer cap, check the
amount of ink in buffer section.
lf ink hides the rib in buffer section,
remove the ink with syringe untill you see
the rib.
When removing the ink, take care not to
mix colors of ink in buffer section.
1-42
15) Fix the ink supply tubes on the rear of the printer
using an ashesive tape.
Figure 1-816
16) Fix the dust cover and roll media cover using an
adhesive tape.
17) Remove the four screws fixing the printer,
earch from right and left sides, and unload the
printer body from the stand.
Figure 1-817
18) Demount the stand.
19) Separately transport the printer body, stand,
ink bottle case, ink bottles, and tube cover after
packing each of them.
CAUTION
When carrying the printer and the ink bottle
case , don't tilt them because ink might flow
out.
COPYRIGHT © 1998 CANON INC.
Advertisement
Table of Contents
