Table of Contents
Advertisement
CHAPTER 3 MECHANICAL SYSTEM
am
. Removing the Carriage Drive Belt
6) Remove the tension stopper
@ turning it clock-
1)
Remove the cover caterpillar unit. (Refer to
wise and remove the tension spring © and the
page 3-7).
tension lever ©.
2) Cancel the capping of the purge unit.
3) Manually move the carriage to the center of the
platen.
4)
Remove the wire guard @ from the right hook.
Figure 3-513
7)
Disconnect the connectors (J401, J403 and
J404) of the short flexible cable from the carriage
PCB.
Figure 3-511
8) Remove the belt stopper ®), pressing the car-
riage drive belt @ to the stopper side. Then,
5) Remove the spring @ and the wire guard @
remove the carriage drive belt.
from the left side of the printer.
Figure 3-514
4. Installing the Carriage Drive Belt
Figure 3-512
:
Install the belt stopper so that the carriage drive
belt is at the position shown in Figure 3-515.
After installing the carriage drive belt, carry out
the adjustment of the carriage drive belt tension.
(See page 5-4.)
paca
i a
Figure 3-515
COPYRIGHT © 1998 CANON INC.
Advertisement
Table of Contents
