Table of Contents
Advertisement
CHAPTER 3 MECHANICAL SYSTEM
ml
13) Remove the right pulley mount @, pulley (right)
16) While pressing the earth plate (left) @ lightly to
@ and pulley tensioner (8.
the other side, remove the linear encoder @
from the left side of the printer.
Figure 3-215
;
Figure 3-217
CAUTION
When the right pulley plate is removed,
CAUTION
take care not to lost the pulley tensioner ©.
* Take the greatest care to handle the linear
encoder. (Refer to page 3-9).
«Install the linear encoder so that the flat
14) Remove the two mounting screws 4 from the
surface of the memory wire edge is set to
right side of the printer and remove the memory
be upward. Make sure that the spring and
wire installation mount (right) (8.
the washer are included in the memory
wire fixing plate (left).
¢ After the linear encoder has been installed,
adjust the tension of the carriage driving
belt. (Refer to page 5-4).
CAUTION
When the pulley (right) is installed, the side
with a mark should be set to be upward.
Mark
Figure 3-216
CAUTION
When a magnetic screwdriver is used, take
care not to let it come close to the memory
wire.
15) Remove the three mounting screws 49 and
Figure 3-218
remove the pulley cover @.
Advertisement
Table of Contents
