Table of Contents
Advertisement
mm CHAPTER 1 GENERAL INTRODUCTION
* The printer loads the inserted media, and
CAUTION
discharges the leading edge of the media
When loading media, do not touch the
from the media exit.
printing surface with your hands. If oil from
« Align the media edge as follows.
your hands touches the printing surface,
@ Lift up the dust cover, and pull the feeder
this might cause uneven printing or smudg-
unit release lever towards you to release
ing to occur.
the feeder unit.
Do not touch ink areas aiter printing.
@ Align the both edge of the media, return
the feeder unit release lever to its original
position, and lower the dust cover.
Figure 1-330
*
The printer then detects the media width
and skewed feed. After this, the printer
trims the leading edge of the media, and
feeds the media to the print start position.
«
{f the printer detects skewed feed, the
printer stops feeding. Align the media
edge again.
4) Set up menus and parameters as necessary.
5) Press the ONLINE key twice.
* The printer leaves the menu display, and
enters the online mode.
6) Transfer the file data from the computer.
* The printer starts printing.
* To stop printing midway, press the ONLINE
key to set the printer to the pause mode.
7) After the print has ended, remove the media
from the printer.
Advertisement
Table of Contents
