Av-Mag Installation Materials And Tools; Additional Required Equipment - uAvionix AV-30-E Installation Manual

d. Mount and align the AV-Mag using brass screws.
e. Enter the orientation of the AV-Mag into the AV-30.
f. If prompted, measure the AV-Mag mounting angles, adjust
mounting to match AV-30 installation attitude, and enter final
angles into the AV-30.
3. Perform AV-Mag Calibration
a. Run a calibration procedure on the installed AV-Mag and
AV-30 pair.
b. Perform a final check of heading. If all headings are off by a
constant amount, the DG adjustment should be used to
compensate.
Record your work in the provided tables and aircraft log book.
11.3.6

AV-Mag Installation Materials and Tools

AV-Mag installation requires access to these tools:
• Non-magnetic Screwdriver and wrench
• Fish tape for pulling wire from cockpit through wing structures
• Drill and drill bit
• Brass fasteners
• (Optional) Non-magnetic digital level or digital protractor/angle
gauge. For example: Johnson Level & Tool 1886-0000
Magnetic Digital Angle Locator (unscrew the back of the case to
remove the built-in magnets)
11.3.7

Additional Required Equipment

AV-Mag is designed to interface with an existing AV-30 display.
UAV-1004234-001, AV-30-E Installation Manual
Rev H
• If necessary, build a bracket for the AV-Mag for
mounting in the correct orientation and alignment.
• Some AV-Mags can report their own roll and pitch
angles to the AV-30. Those angles are visible on the
second to last screen of the AV-Mag installation.
58