Enable The Av-Mag - uAvionix AV-30-E Installation Manual

11.3.8

Enable the AV-Mag

Use of the AV-Mag is enabled through the AV-30 installation menu.
Before applying power, push and hold the center rotary knob and apply
power. As the AV-30 splash screen appears, check that a minimum
version of 2.3.0 is displayed. AV-Mag support is not available on units
with software versions prior to 2.3.0.
Enter the AV-30 installation menu and navigate to the serial 4 interface
option (SERIAL 4). Set SERIAL 4 to AVMAG.
While SERIAL 4 is set to AVMAG, the AHRS aiding mode (AID MODE)
will automatically be set to AVMAG and cannot be changed.
Enter the AV-30 installation menu again and navigate to the AV-Mag
installation menu (AVMAG INSTL). Push the center rotary knob, then
press the right button to begin the installation process. If AV-Mag is not
properly connected, the version will indicate "Not detected".
UAV-1004234-001, AV-30-E Installation Manual
Rev H
59