uAvionix AV-30-E Installation Manual page 127

1. Monitor a local frequency and verify there are no unintended squelch
breaks or other tones that would interfere with communications.
2. Monitor a remote (distant) frequency and verify there are no
unintended squelch breaks or other tones that would interfere with
communications.
3. Monitor an unused frequency and verify there are no unintended
squelch breaks or other tones that would interfere with
communications.
Verify VHF NAV operates without interference from the AV-30-E.
1. Power on the VHF NAV radio.
2. Monitor a local, remote, and unused frequency.
3. Verify there are no misleading navigation indications during the
monitoring of each frequency.
4. Verify audible station ID and that the station is clear of audio
interference that would prevent identification.
Additional Avionics should be tested according to the manufacturer
EMC/EMI test procedures. This testing assumes the existing equipment
is functional and operating correctly at time of testing. The following
summarizes a typical EMC test.
1. Operate the AV-30-E.
2. Operate the existing installed avionics according to manufacturer
instructions. If capable, utilize the device transmit and receive
functions through a range of values.
3. Verify no errors, warnings, or unexpected operation is observed on
the AV-30-E during operation of the installed avionics.
4. Verify no errors, warnings, or unexpected operation is observed on
the installed avionics during operation of the AV-30-E
UAV-1004234-001, AV-30-E Installation Manual
Rev H
VHF NAV RADIOS
ADDITIONAL AVIONICS
.
127