uAvionix AV-30-E Installation Manual page 129

Interface
GPS information is expected but
does not show up in data
"NO DATA" is shown.
"NO GPS" is shown.
Splash screen shows "ERROR:
Problem with bootloader.
Factory service required."
Splash screen shows "ERROR:
PROV value check failure.
Service required."
Splash screen shows "ERROR: F-
CAL value check failure.
Verify user calibration
data."
"NO AP" flag is displayed on startup
"NO AP" flag is displayed when
selecting an autopilot mode or while
AP is active
Alerts
Audio alerts not heard over the audio
system
Nuisance alerts are
UAV-1004234-001, AV-30-E Installation Manual
Rev H
overlays.
generated.
Check GPS input is configured to match the
connected GPS serial data type and speed.
Set direction indication to GPS
Check interface cables and
Check GPS input is configured to match the
connected GPS serial data type and
Contact uAvionix support
Contact uAvionix support
Check Altitude Trim LO/HI, IAS trim LO/HI, Pitot-zero
setting, and magnetometer installation and calibration
data. Re-execute any field calibrations that show
values not matching records.
If occurring on startup, check interface cables and
pinout between AV-APA and AV-30-E
This indicates that the AV-30-E is either not
communicating with the AV-APA (see above), or that
the AV-30-E does not have the required information to
perform the mode selected. If using an autopilot mode
that uses GPS, ensure that the GPS has signal and
has an active flight plan
Check wiring and ensure alerts are enabled in the
Setup menu.
Ensure unswitched input is available on the audio
panel.
Verify volume setting is sufficiently high in the Setup
menu.
Ensure alerting limits are configured as desired in the
Setup menu.
TRK.
pinouts.
speed.
129